How to fix belt slipping on TMG Lawn Mower?
To address belt slippage in your TMG Lawn Mower, start by unplugging the mower and cleaning the mower deck. Then, remove the belt guard shields and clean the sheaves. If the problem persists, replace the belt. Ensure you're mowing at full throttle (540 PTO rpm), and verify both the PTO speed and the tractor engine.
What to do if TMG Lawn Mower leaves patches of uncut grass?
If you're noticing patches of uncut grass while using your TMG Lawn Mower, try shifting the transmission to a lower gear. Also, check and tighten the belts. Finally, inspect the knives and replace any that are missing or damaged.
How to fix uneven cut with TMG Lawn Mower?
If your TMG Lawn Mower is producing an uneven cut, try shifting to a lower gear. Ensure the mower is level. Check the knives and replace any that are missing.
What to do if TMG Lawn Mower knives are scalping grass?
If the knives on your TMG Lawn Mower are scalping the grass, raise the cutting height by adjusting the roller. Consider changing your mowing pattern, and reduce speed during turns.
Read and understand instructions before operation. Refer to Safety Decal.
Read and understand safety label section and instructions.
Comply with laws, max 20 mph, adjust speed for terrain.
Riders obstruct view and pose a safety risk.
Children should never operate the equipment.
Understand procedures, use tools, work in clean area, follow safety steps.
Wear appropriate clothing, hearing protection, avoid headphones.
Relieve pressure before disconnecting lines, use paper to check leaks.
Designed for 3-point category 1 hitch, max 50 PTO HP tractor.
Procedures for safely moving the mower to the work area.
General| Brand | TMG |
|---|---|
| Model | TMG-TFMO60 |
| Category | Lawn Mower |
| Language | English |
To Next Page
