What to do if the oxygen connection is open on TNI Medical Equipment?
If the oxygen connection is open on your TNI Medical Equipment, close the oxygen inlet port using a protective cap. Alternatively, verify the correct setup of the oxygen source.
What to do if applicator heating is defective in TNI softFlow 50 Medical Equipment?
If the applicator heating is defective on your TNI Medical Equipment, please replace it with a new applicator.
What to do if TNI Medical Equipment displays 'SD card or file defective'?
If your TNI Medical Equipment says 'SD card or file defective', change the SD card and restart the system. If the error continues, contact your TNI medical AG representative.
What to do if TNI softFlow 50 displays 'Low SD card memory'?
If your TNI Medical Equipment indicates 'Low SD card memory', please insert a new SD card.
What to do if TNI softFlow 50 displays 'Change dust filter'?
If you receive a message to change the dust filter on your TNI Medical Equipment, you should change the dust filter.
What to do if the flowrate is too high on TNI Medical Equipment?
If the flowrate is too high on your TNI Medical Equipment, check the air flow.
What to do if the pressure is too high in TNI Medical Equipment?
If the pressure is too high on your TNI Medical Equipment, you should check the air flow.
What to do if the flow rate is not reachable on TNI softFlow 50?
If the flow rate is not reachable on your TNI Medical Equipment, ensure you check the air flow and the type of applicator being used.
What to do if TNI softFlow 50 Medical Equipment says 'Please refill water'?
If your TNI Medical Equipment indicates that you need to refill water, please refill the humidification chamber with water.
General| FiO2 | 21 - 100 % |
|---|---|
| Patient Population | Adult, Pediatric |
| Operating Modes | Continuous |
| Humidity Range | 10-95% non-condensing |
| Power Supply | AC 100-240V, 50/60Hz |
To Next Page
