Pairing and intercom between headsets
1. Pairing and intercom between two Bluetooth intercoms (A,B)
Active/passive pairing operation:
1) Turn on the two Bluetooth intercoms (A,B), press and hold the B intercom
[multi-function button] for 3 seconds.At this time, red and blue lights alternately
flashing, passive pairing mode on.
2) Short press the [intercom button] of A for 3 seconds, red and blue lights
alternately slow flashing, into the active pairing mode.When you hear the "search"
prompt voice, active pairing is on.
(3) voice prompt "device has been connected", the two intercoms connected
successfully, the blue light flashes slowly.
Attention：
1. After the intercom pairing is successful, when intercom, if there is a cell phone
call, the device will automatically cut off intercom. After the call is over, it will
automatically connect back to the intercom state.
2. In the process of intercom, because of distance or environmental factors such
as disconnection, you can manually short press the [intercom button] once,
manually back to connect.
3. When the device is in standby mode, short press the [intercom button] to turn
on the intercom; short press the [intercom button] to turn off the intercom in the
intercom state. Short press the volume up/down button to adjust the call
volume.
About 3 sec
About 3 sec
To Next Page
Loading...
