Need help?Do you have a question about the Toa MX-106R and is the answer not in the manual?
General| Channels | 6 |
|---|---|
| Phantom Power | Yes |
| Dimensions | 214 (W) × 78.5 (H) × 227 (D) mm (8.43" × 3.09" × 8.94") |
| Weight | 2.4 kg (5.29 lb) |
| Frequency Response | 20 Hz - 20 kHz |
| Microphone Inputs | 4 |
| Line Inputs | 6 |
| Output Channels | 2 |
| Equalizer | 3-band |
| Output Connectors | XLR |
| Total Harmonic Distortion | 0.1% |
| Power Supply | AC 230 V, 50/60 Hz |
Details on the 6 input channels, EQ, sends, and master controls like graphic EQ and reverb.
Information on the power amplifier rating, protection circuitry, and patch bay capabilities.
Explanation of Peak Indicator, TRIM, EQ, and Level controls for each input channel.
Description of master section controls like PGM, FB, Reverb/Effects, and Aux.
Details on XLR, 1/4" phone jacks, and patch bay connections on the front.
Information on the power switch, speaker jacks, AC cord, and grounding terminal.
Notes on cord wrap, ventilation, fuse replacement, and unit operation.
Diagrams illustrating connections for microphones, instruments, and tuners.
Examples for connecting to main/sub mixers, tape decks, and speaker systems.
Guidance on matching impedances and levels for proper input connections.
Table detailing connector types, impedances, and sensitivity for each input.
How to set input levels using TRIM and INPUT LEVEL for best S/N ratio.
Understanding the PEAK LED and the mixer's fault protection table.
Internal signal path and component overview shown in the block diagram.
Chart illustrating signal levels at various points in the mixer's signal chain.
Details on frequency response, THD, noise, impedance, and input/output levels.
Data on rated power, amplifier performance, dimensions, and weight.
Graphs showing EQ curves, power amp bandwidth, and reverb frequency response.
Charts detailing power amp compressor and total harmonic distortion.
To Next Page
