Assembly instructions
1.
2.
6a.
6b.
3. 4.
5.
It is very important that the tilt screw is
tightly fastened once the tilt has been
set. Otherwise, there is a risk that the
monitor and eye tracker will tilt by itself
at a later time.
7.
8.
Before mounting the arm, ensure that
the table or wall you are mounting it on is
sturdy enough to support the asymetrical
weight distribution caused by the monitor
and the eye tracker.
If a table, which is not fit for the purpose
is used, there is a risk that the table will tip
over when the monitor and the eye tracker
are attached or adjusted. A tipping table
with the additional weight of the monitor
and the eye tracker can seriously hurt
anyone who is positioned in the direction in
which it tips.
To Next Page