What to do if my TOHATSU Outboard Motor engine overheats?
If your TOHATSU Outboard Motor engine overheats, it could be due to a few reasons: * Lack of cooling water: Check and refill the cooling water. * Defective or clogged pump: Service or replace the water pump. * Defective thermostat: Test and replace the thermostat if necessary.
Why TOHATSU MFS 20E Outboard Motor engine speed is very high?
If the engine speed of your TOHATSU Outboard Motor is very high, causing the high-speed ESG to operate, inspect the throttle control and linkage.
General| Power Output | 20 HP |
|---|---|
| Gear Ratio | 2.08:1 |
| Shaft Length | 20 inch |
| Full Throttle Operating Range | 5000-6000 RPM |
| Fuel System | EFI (Electronic Fuel Injection) |
| Fuel Tank Capacity | 12 L |
| Output | 14.7 kW |
| Control Type | Tiller Handle |
| Fuel Type | Unleaded Gasoline |
| Steering | Tiller |
| Engine Type | 2-cylinder, 4-stroke |
| Starting System | Electric or Manual |
Indicates severe personal injury or death, and property damage.
Indicates severe personal injury, death, or property damage.
Indicates personal injury or property damage.
Emphasizes operator responsibility for safety and following regulations.
Explains the function and use of the stop switch lanyard.
Stresses owner's responsibility for maintenance and safety inspections.
Warns about the danger of carbon monoxide gas.
Warns about gasoline's flammability and explosiveness.
Provides instructions for mounting the outboard motor onto a boat.
Guides on how to properly install the battery.
Covers general safety and recommendations for handling fuel.
Provides instructions and warnings for filling the fuel tank.
Lists warning indicators, their causes, and remedies.
Covers pre-start checks, including oil level.
Provides instructions for starting the engine.
Outlines the procedure for emergency starting with a rope.
Continues instructions for emergency starting with a rope.
Explains the process of warming up the engine.
Details how to shift between forward, reverse, and accelerate.
Provides instructions on how to stop the engine.
Describes how to steer the outboard motor.
Provides instructions for tilting the outboard motor up and down.
Explains how to tilt up and down for manual tilt models.
Explains how to tilt up and down for power tilt models.
Provides guidance for operating the motor in shallow water.
Details how to adjust the trim angle.
Emphasizes the importance of regular maintenance for optimal performance.
Lists checks to perform before and after each use.
Presents a schedule for periodic maintenance tasks.
Provides instructions for changing engine oil.
Details the step-by-step process for changing engine oil.
Guides on how to replace the oil filter.
Provides instructions for replacing gear oil.
Guides on how to replace the propeller.
Details how to replace spark plugs.
Provides instructions for preparing the motor for off-season storage.
Lists checks to perform before using the motor after storage.
Outlines emergency steps if the motor strikes an underwater object.
Lists troubleshooting for fuel and lubrication issues.
Lists troubleshooting for electrical system issues.
To Next Page
