INSPECTION AND MAINTENANCE 69
10
z Wipe off engine oil well immediately if
spilled and dispose of it in accordance
with local fire prevention and environ-
ment protection regulations.
z Do not replenish engine oil over upper
limit. If overfilled, remove oil to upper
limit. If engine oil is over the upper limit, it
can leak potentially leading to engine
damage.
If the oil level is low, or at lowest mark,
add recommended oil to the middle dip-
stick mark.
ENOM00083-B
Washing outboard motor
ENOW00920-0
When washing the outboard motor, be care-
ful not to spray the water inside of the top
cowl, especially electrical components.
ENON00026-0
Note
It is recommended to check chemical
properties of water on which your out-
board motor is regularly used.
If outboard motor is used in salt water,
brackish water or water with high acidic
level, use fresh water to remove salt,
chemicals or mud. And flush cooling
water passage after every use or before
storing outboard motor for long time.
Before flushing, remove the propeller
and the forward thrust holder.
ENOM01903-0
Gear case flushing device
ENOW00082-0
Never start or operate the engine indoors or
in any space which is not well ventilated.
Exhaust gas contains carbon monoxide, a
colorless and odorless gas which can be fatal
if inhaled for any length of time.
ENOW00986-0
Never leave the outboard motor unattended
while running on the flushing devise. When
the flushing devise slip off from the gear
case, the engine will overheat and may cause
serious damage.
CAUTION
WARNING
CAUTION
To Next Page
Loading...
Need help?
General
