ENGINE OPERATION54
7
1. Perpendicular to the water surface
ENOM00053-0
Improper trim angle (bow rises too
high)
Set the thrust rod lower if the bow of the
boat rises above horizontal.
ENOM00054-0
Improper trim angle (bow dips into the
water)
Set the thrust rod higher if the bow of
the boat is below horizontal.
1. Thrust rod
2. Higher
3. Lower
Trim angle adjustment
The transom angle adjustment
1. Stop the engine
2. Shift into neutral position.
3. Tilt up the outboard motor.
4. Lock the tilt stopper
5. Remove the snap pin and thrust rod
as shown picture.
1. Snap pin
2. Thrust rod
6. Reinstall the thrust rod in the desired
position securely.
7. Put the snap pin back and unlock the
tilt stopper.
8. Gentry tilt down the outboard motor.
ENOF00053-0
To Next Page
Loading...
Need help?
General
