Need help?Do you have a question about the Tohnichi CEM20N3X10D-G-BTA and is the answer not in the manual?
General| Model | CEM20N3X10D-G-BTA |
|---|---|
| Category | Measuring Instruments |
| Type | Digital Torque Wrench |
| Torque Range (N·m) | 2-20 |
| Torque Range (kgf-cm) | 20-200 |
| Torque Range Increment (N-m) | 0.01 |
| Torque Range Increment (kgf-cm) | 0.1 |
| Torque Range Increment (lbf-in) | 0.1 |
| Display | Digital |
| Material | Steel |
| Handle Type | Ergonomic |
| Calibration Certificate | Included |
| Accuracy | ±1% |
| Applicable Driver Bit | Hex |
| Drive Size | 1/4" |
Lists the key features of the torque and angle wrench, including data recording and wireless transmission.
Explains how the tool judges results based on set torque and angle thresholds.
Details the functions of each button on the torque and angle wrench for various operations.
Describes the Inspection (MODE-M) and Tightening (MODE-T) modes for measurements.
Explains the RUN and Peak modes of the tool's display for showing data.
Explains how the tool measures and outputs angle data when configured.
Lists common error messages (Err0-Err9) and their corresponding solutions.
Describes how the tool performs judgments based on set torque, angle, and detection parameters.
Explains the over-torque alarm functionality when exceeding the maximum torque.
Shows an example of operating the tool in Tightening mode (MODE-T) with specific settings.
Shows an example of operating the tool in Inspection mode (MODE-M) with specific settings.
Explains the communication data formats (M3+ID, M-3) affecting data strings.
Lists the input commands for remotely changing settings and controlling the tool.
Lists all configurable setting items, their defaults, and selectable options.
Explains how to change settings using the tool's keys and navigation.
Explains how to output measurement data in batches by specifying a range.
To Next Page