B-10
OPERATION
B-10
GOUGING SETUP:
If gouging metal and not cutting completely through
the part is required, a special gouging nozzle is used
in conjunction with a gouge shield to protect the noz-
zle from molten metal blow back.
Refer to the torch parts decal located on your machine
or the parts pages at the back of this manual for the
specific part numbers required for each of these
setups.
ALWAYS USE GENUINE LINCOLN ELECTRIC
ELECTRODES, NOZZLES, AND EXPENDABLE
PARTS FOR THE BEST CUTTING PERFOR-
MANCE.
TOMAHAWK™ 1000
www.lincolnelectric.com
3-10
To Next Page
Loading...