align with the top two points on the side supports.
4. Align the pre-drilled holes in each end of the tube with the pre-
drilled holes in each side support.
5. Place a washer on the bolt for each side. Insert a bolt
through all pre-drilled holes and tighten.
IMPORTANT: After all brush guard components have been at-
tached to the main frame of the kart, please tighten all bolts to ensure
that the brush guard is held firmly in place. Do NOT attempt to oper-
ate this go-kart unless all bolts have been properly tightened.
16
To Next Page
Loading...
