EasyManua.ls Logo

Tommee Tippee Digital ear thermometer - Warnings and Precautions; General Safety Warnings; Intended Use; Choking Hazard

Tommee Tippee Digital ear thermometer
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Correct installation of the hygiene cover ensures accurate readings.
Using the thermometer without a hygiene cover may cause inaccurate readings.
Do not submerge the device in any liquids or expose it to direct moisture.
This thermometer is not intended as a substitute for a doctor’s consultation.
If the condition does not improve consult your doctor.
This is not an AP or APG product.
Intended use: The infrared ear thermometer can measure the infrared heat
generatedbyeardrumareaandsurroundingtissuestoreectpatient’sbody
temperature accurately.
Choking from swallowing hygiene covers and connection ring by children or pets
is possible, please keep out of reach of children and pets.
TEMPERATURE ALARM
If the thermometer detects a body temperature 99.5°F (37.5°C), one long beep will
sound followed by three short beeps to warn the user of potential fever.
SWITCHING BETWEEN FAHRENHEIT (°F) AND CELSIUS (°C)
In ‘Power off’ mode, press and hold the ‘Scan’ button.
Then press the ‘On/Mem’ button for 3 seconds whilst still holding the scan button. The
‘°C’ will change to ‘°F’. You can use the same process to change from ’°F’ back to ‘°C.
MEMORY FUNCTION
Press the ‘On/Mem’ button again to see the last temperature stored. The thermometer
will automatically save the last reading into the memory, if it is within the temperature
range of 93.2°F to 108.0°F (34°C to 42.2°C).
Beforerstuse,pulltoremovethetabfromthebatterycover.
Correct installation of the hygiene cover ensures accurate readings. Always use a
new and undamaged hygiene cover before each reading.
WARNINGS AND PRECAUTIONSWARNINGS AND PRECAUTIONS
FUNCTIONSFUNCTIONS
INSTALLING THE HYGIENE COVERINSTALLING THE HYGIENE COVER
3.
1. 2.
Gently twist the probe cap
to remove.
Place a new hygiene cover
into the connection ring.
Insert the thermometer probe
into the centre of the hygiene
cover and connection ring.