4
To remove the cover from the device, first remove the mount. Then hold either
side of the cover and push through the center of the cover to detach the device
from the cover as shown in the diagram. To attach the new cover, push it gen-
tly into place as shown.
Troubleshooting
In rare cases, your TomTom EASE navigation device may not start correctly
or may stop responding to your taps.
First, check that the battery is properly charged. To charge the battery, con-
nect your device to the car charger.
If this does not solve the problem, you can reset the device. To do this, do the
following.
1. Remove the Mount from the device by pressing the release button on the
Mount.
2. Pull the back cover off the device by holding either side of the cover and
pushing the device through the center of the cover.
3. Use a straightened paper clip, or something similar, to push the reset but-
ton. The reset button is on the bottom of your device.
To Next Page
Loading...
Need help?
General
