EN
Permanent mounting
21
Using sticky pads
You can also affix the TomTom LINK with the
two sticky pads. Follow the safety
instructions in this document.
1. Choose a flat surface for accurate
positioning of the TomTom LINK.
2. Clean the surface with a clean and dry
cloth, so that the surface is oil free, dry and
clean.
3. Remove the protective film from one side
of the pad and stick it to the bottom side of
the TomTom LINK. Repeat the same
procedure with the second sticky pad.
4. Remove the protective films from the other
side of both pads.
5. Place the TomTom LINK with the sticky
pads downwards on the prepared surface.
Press it gently and hold it for a few seconds
until it sticks.
Important
Make sure you do not damage the TomTom LINK.
Follow the safety instructions in this document.
To Next Page
Loading...
Need help?
General
