Tomy Verbot - Checklist for Correcting Disorders

"nliiiii"ft"l~ I rvn "vnnliiiii" IIIIII,.U WI~Vn"IIiiiBIf"'B""
COMPLAINT CAUSE CHECK
Verbot does not
1. The Transmitter Switch is OFF. 1. Turn the switch ON.
accept programming.
(will not memorize
2. There is Radio Frequency interference.
2. Try it in a different place or at a
the word)
different time.
3. The Command is too short or too long.
3. Limit the Command to a rlJaximum
of 1.2 seconds, and longer than
.2 seconds.
4. The two antennas are touching
4. Separate the two antennas.
each other.
5. The batteries are running low.
5. Replace the batteries with new ones.
(Refer to section on Battery
Replacement) .
Verbot does not make
1. It is the wrong 1. Check your programming chart or
proper movements.
re-program the Command into
Verbol.
2. There is Radio
interference.
2. Try it in a different place or at a
different time.
3. The word is not recorded correctly.
3. Enter the wording once again.
4. There is too much noise in the area. 4. Move to a quieter area.
5. The batteries are low.
5. Replace the batteries with new ones.
(Refer to section on Battery
Replacement).
14