Toolocity T-Rex - Tighten Input Shaft with Angle Wrench; Verify Spindle Tightness

Applied Diamond Tools
18102 Chesterfield Airport Rd, Unit O
Chesterfield, MO 63005
Phone: 636-537-5888 Toll Free: 800-980-7808
Fax: 800-758-9968
Email: sales@applieddiamondtools.com
4
6. Use angle Wrench to twist input shaft counter-clockwise, until spindle is tight.
7. Press down on the self-lock button on the polisher. Turn the back holder
clockwise to check if the spindle of the polisher is tightly turned into the input
shaft.
Use angle wrench
to
turn Counter-clockwise.
Back holder
Ch
eck if shafts are
threaded tightly.
Press
self-lock
button