12
OPERATION METHOD
25
Blowing Function
1. Make sure the tank is empty and completely
dry before using it as a blower.
2. Connect the exible hose to the Flexible
Hose Outlet – Blower by inserting into the
outlet and aligning the arrow and locking
pin on the end of the exible hose, with the
ridge on the top of the Flexible Hose Outlet –
Blower. Rotate the exible hose to the left to
secure the hose into position.
3. Select and attach additional extension tubes
if required.
4. Before turning ON, ensure you are rmly
holding the end of the exible hose, or
extension tube/s if added.
5. Press the “I” on the ON/OFF Switch to turn
ON. To turn OFF, press the “O” on the ON/
OFF switch.
WARNING: Wear a dust mask and eye protection if blowing creates dust that
might be inhaled.
WARNING: Keep bystanders clear from blowing debris.
CAUTION: Any material left in the tank may be blown out, causing injury.
To Next Page
Loading...
