13
MAINTENANCE
Cleaning
• Keep all safety devices, air vents and the motor housing and appliance head free
of dirt and dust.
• We recommend that you clean and dry the appliance immediately after each use.
Cleaning the Appliance Head
• Clean the appliance head regularly with a damp cloth and some soap followed by
wiping down and drying before storing away.
• Do not submerse the appliance head in water or allow water to enter the
appliance head.
• Do not use cleaning agents or solvents. These may be aggressive to the
plastic parts on the appliance.
Cleaning the Tank
• The tank can be cleaned with a damp cloth and soap or rinsed under running
water depending on the amount of dirt. Wipe down and dry before storing away.
Cleaning the HEPA Filter
• Clean the HEPA lter regularly by carefully patting it and cleaning it with a ne
brush or hand brush (not supplied).
• Do not submerse the HEPA lter in water. Do not use a damp cloth to clean.
Cleaning the Foam Filter
• Clean the foam lter with a little soap under running water.
• Allow the foam lter to completely air-dry before reinstalling or storing away. Do
not wring dry.
Check the Floating Safety Valve
• Check the oating safety valve often to ensure it moves freely within the lter
basket. To do this, take the appliance head by the handle and tip it carefully so
that the lter basket is facing upwards. The oating safety valve should move
freely up and down.
General Maintenance
• Before each use, inspect the general condition of the appliance and check for the
following:
• Loose hardware or screws.
• Misalignment or binding of moving parts.
• Damaged or electrical wiring.
• Check lters are securely tted.
• Damaged or cracked tank.
• Any other condition that may affect safe operation
If the supply cord is damaged, it must be replaced by the manufacturer,
its service agent or similarly qualied persons in order to avoid a hazard.
To Next Page
Loading...