4
1. Connect positive red power cable with the + terminal of the battery.
2. Connect negative black power cable with the - terminal of the battery.
3. Connect the DC power cable to the transceiver's power supply connector.
▲ If a cigarette lighter is used, use one rated for at least 10 Amps.
▲ Locate the power cable away from high temperature, moisture, port
re and cable
insulator.
▲ Use a full power cable even it is longer than need, do not take off the fuse holder
from the cable.
Connected
to chassis
Replacing Fuse
This radio requires a 10A, 250V fuse. NEVER USE A FUSE WITH A HIGHER RATING.
If the fuse blows, determine the reason, then correct the problem.
After the problem is resolved, replace the fuse. If newly installed fuses continue
to blow, disconnect the power cable and contact your authorized dealer or an
authorized servicecenter:
1. Pull the two fuse cover in difference direction and open it.
,
IN-LINE
FUSE HOLDER
2.
Replace the blown fuse with good one, and close the fuse holder.
3. Be sure to use suggested fuse, or it might damage the radio.
FUSE
IN-LINE
FUSE HOLDER
IN-LINE
FUSE HOLDER
IN-LINE
FUSE HOLDER
10A 250V FUSE
To Next Page
Loading...