3
Microphone connection
1. Plug microphone connector into jack.
2. Pull on the screw for microphone connector.
ANTENNA INSTALLATION
POWER CONNECTION
B
efore using this radio, please install a high efficent and properly adjusted
CB antenna, suitable antenna type and correct installation will provide
excellent communication.
Always use 50 Ohm coaxial cable for a single antenna and 75 Ohm cable for a dual
antenna system. Your antenna system should be 1.5:1 SWR or lower for best
performance. A SWR of 3:1 or higher could damage the transmitter.
1. Screw the antenna connector into the antenna jack.
2. Grounding the antenna system to ensure best performance of this radio.
This radio adopt 13.8V power supply, never connect it to 24V battery, And the 13.8V car
battery shall with sufcient current, or the LCD will become dark and Transmit power
will drop down.
3. The position of antenna can be put as following example:
WARNING:
▲ Always connect the
antenna before transmiting, or it might damage the radio.
▲ To avoid the risk of fire, electric shock, radio damage, all base station should
be equipped with a lightning protector.
▲ Be sure choose a matching antenna, Check with your local dealer.
MIC
VOL
SQ
MIG
OFF
RFG
PA
FM
AM
B
C
D
E
DATA
RX/TX
BAND
H
DIM
RF PWR
HI
NB/ANL
ANL
OFF
LO
M
L
OFF
BAND
TX
P
W
R
+30
dB
23
4
9
753
1
�`�$�T
1
H
L
E VOL E DL
Y
NOR
EM
G
MIC
VOL
SQ
MIG
OFF
RFG
PA
FM
AM
B
C
D
E
DATA
RX/TX
BAND
H
DIM
RF PWR
HI
NB/ANL
ANL
OFF
LO
M
L
OFF
BAND
TX
P
W
R
+30
dB
23
4
9
753
1
�`�$�T
1
H
L
NOR
EM
G
E VOL E DL
Y
To Next Page
Loading...