11
Register/de-register a handset
8.3 Calling a number from the call list
8.4 Erasing a number from the call list
8.5 Storing a number from the call list into the memory
9 Register/de-register a handset
9.1 Register a handset to a Topcom Butler 900 base
You can subscribe up to 5 handsets to one base unit. By default, eacht handset is subscribed on the
base unit upon delivery.
You only need to subscribe the handset if:
• the handset subscription has been removed from the base unit (e.g. for reinitialisation)
• you want to subscribe a different handset to this base unit.
The below procedure is only applicable to a Topcom Butler 900 handset and base unit!
1 Press the call log key.
2 Scroll through the call list until the desired telephone number is displayed.
3 Press the line key to start the call.
The number will be dialled automatically.
4 Press the line key again when you want to terminate the call.
1 Press the call log key
.
2 Scroll through the call list until the desired telephone number is displayed.
3 Press and hold the mute key for 3 seconds to erase the number.
1 Press the call log key.
2 Scroll through the call list until the desired telephone number is displayed.
3 Press and hold the memory key for 3 seconds.
4 Enter the memory location (0-9) where you want to store the number.
5 Enter the memory key again to confirm.
1 Press and hold the paging key on the base unit for 10 seconds.
The handset on charger LED on the base unit begins to blink rapidly for 1
minute.
During this minute, the base unit is in register mode and you must do the
following to subscribe he handset:
2 Press and hold the right key for 3 seconds.
3 Press and hold the *-key for 3 seconds.
456
g h i j k l m n o
To Next Page
Loading...
