Topcom ultra range series - Out of Range; Setting the Loudspeaker Volume; Call Duration Display; Mute

19
8OWUD5DQJH
(1*/,6+
 2XWRIUDQJH
If the handset is out of range of the base station:
•‘6($5&+,1*’ appears in the display and the symbol
flashes in the display.
1. Move closer to the base station or repeater/charger.
2. The symbol stops flashing and is displayed permanently.
• This means you are back within range of the base station.
 6HWWLQJWKHORXGVSHDNHUYROXPH
Press or during the call to adjust the loudspeaker
volume. You can choose between 5 different settings. The default
setting is level “3”:
 &DOOGXUDWLRQGLVSOD\
The call duration is shown in the display during an external call:
A display of ‘’ means: 1 hour, 10 minutes and 40 seconds.
The call duration is shown in the display for another 8 seconds
after the call is ended.
 0XWH
Press the mute key to deactivate the microphone during a
call. You can now speak freely without the party on the other end
of the line being able to hear you. The mute key
must be
pressed again to reactivate the microphone.
 3DXVHNH\GLDOOLQJSDXVH
If you want to insert a dialling pause while dialling a telephone
number, press the pause key 3 for 2 seconds at the
appropriate point in the number until a P appears in the display.
If you then dial this number (or select it for redial), the dialling
pause (approx. 3 seconds) is automatically dialled too.
 )LQGLQJWKHKDQGVHWIURPWKHEDVHVWDWLRQ
SDJLQJ
If you cannot find the handset, briefly press the paging key
on the base station. All handsets registered on the base station
ring which allows them to be located. Press any key on the handset
to stop it ringing.
 8VLQJWKHDOSKDQXPHULFNH\SDG
Use the alphanumeric keypad to enter a text. Press the
appropriate alphanumeric key to select a letter. For example, if you
press the ‘5’ numeric key, the letter ‘J’ appears in the display first.
Press the key repeatedly to enter other characters assigned to this
key.
Press the ‘2’ key once to select the letter ‘A’. If you want to enter
‘A’ and ‘B’ in succession, first press the ‘2’ key once to select the
letter ‘A’. Then wait for a second to move to the second character,
then press key ‘2’ twice to enter ‘B’. You can use the escape key
(6& to delete letters that have been entered incorrectly. The
character before the cursor is deleted. All characters in an entered
sequence can be deleted at once by pressing and holding the
escape key (6& for 2 seconds.
The batteries discharge more quickly if you use hands
free mode for a long time!
If the out of range warning tone is activated (see “4.20
Switching the range warning tone on/off”) you will hear a
warning beep before going out of range.
The volume is adjusted in the same way in hands free
mode.
4 15
2
2
8
22
3
3