Topcom ultra range series - Switching the Keypad Beep On;Off; Switching the Range Warning Tone On;Off; Switching the Battery Low Warning Tone On;Off; Switching the Charge Tone On;Off

21
8OWUD5DQJH
(1*/,6+
 6ZLWFKLQJWKHNH\SDGEHHSRQRII
You can set the handset so that a beep is generated whenever you
press a key.
1. Press
twice.
2. Press or repeatedly, select ‘+$1'6(7721(6’.
3. Press to confirm.
4. Press or repeatedly, select ‘.(<%((3’.
5. Press to confirm.
6. Select:
–‘21’: switches the keypad beep on;
–‘2))’: switches the keypad beep off.
7. Press to confirm your selection or press (6& to
exit the menu without saving the setting.
 6ZLWFKLQJWKHUDQJHZDUQLQJWRQHRQRII
You can set the handset so that a beep is generated whenever you
are almost out of the base range during communication. When you
hear this beep you have to move closer to the base again (see also
“4.9 Out of range”).
To turn this on/off you have to follow above procedure (see “4.19
Switching the keypad beep on/off”) but select ‘5$1*(721(’
instead of ‘.(<%((3’.
 6ZLWFKLQJWKHEDWWHU\ORZZDUQLQJWRQHRQRII
You can set the handset so that a beep is generated when the
battery is almost empty. To turn this on/off you have to follow
above procedure (see “4.19 Switching the keypad beep on/off”) but
select ‘%$77(5<721(’ instead of ‘.(<%((3’.
 6ZLWFKLQJWKHFKDUJHWRQHRQRII
You can set the handset so that a beep is generated whenever you
place the handset inside the base or charger.
To turn this on/off you have to follow above procedure (see “4.19
Switching the keypad beep on/off”) but select ‘&+$5*(721(’
instead of ‘.(<%((3’.
 &KDQJLQJWKHKDQGVHWQDPH
Proceed as follows to change the handset name that is shown in
the display in standby mode:
1. Press
twice.
2. Press or repeatedly, select ‘+$1'6(71$0(’.
3. Press to confirm.
4. Press (6& repeatedly to delete the letters in succession
and use the alphanumeric keypad to enter a new name.
5. Press to set the new handset name.
 $XWRWDON
When the handset is in the base station and receives an incoming
call, the call is answered automatically when the handset is
removed from the base station or charger. You can choose
whether or not this function should be activated.
1. Press
twice.
2. Press or repeatedly, select ‘$872$16:(5’.
3. Press to confirm.
4. Select ‘21’or ‘2))’and press to confirm.
 $XWRKDQJXS
When the handset is in communication, the call is ended when
handset is placed inside the base station or charger when auto
hang-up is on. If auto hang-up is off during talk mode, the handset
17
4 15
17
4 15
17
17
3
17
4 15
17
3
17
17
4 15
17
17