Topdon Phoenix Lite 2 - Operation: Special Functions; DPF Regeneration and Tooth Learning

27
EN
3.6 BRAKE (Electronic Parking Brake Reset)
This function helps you to replace and reset the brake pads.
It needs to be performed in the following cases:
•
The brake pads and brake pad wear sensor are replaced.
•
The brake pads indicator lamp is on.
•
The brake pads sensor circuit is short, which is recovered.
•
The servo motor is replaced.
3.7 DPF (DPF Regeneration)
This function can help remove particulate matter from the trap by using combustion
oxidation methods to keep the performance of the trap stable.
It needs to be performed in the following cases:
3.8 GEAR (Tooth Learning)
3.10 INJEC (Injector Coding)
3.11 TPMS (Tire Pressure Reset)
3.9 IMMO (Anti-theft Matching)
This function can perform tooth learning for the car to turn off the MIL.
This function can write injector actual code or rewrite code in the ECU to the injector
code of the corresponding cylinder, so as to have more accurately control or correct
cylinder injection quantity.
This function can reset the tire pressure and turn off the tire pressure fault indicator
when the car tire pressure fault indicator light is on.
This function can match the anti-theft key after replacing the ignition key, ignition
switch, instrument cluster, engine control unit (ECU), body control module (BCM), and
remote control battery.
It needs to serve in the following cases:
It needs to be performed in the following cases:
•
After the engine ECU, the crankshaft position sensor or crankshaft flywheel is replaced.
•
There is a DTC of 'tooth not learned.'
•
After the ECU or injector is replaced.
•
Replace the exhaust back pressure sensor.
•
Disassembly or replacement of the particle trap.
•
Removal or replacement of fuel additive nozzles.
•
Removal or replacement of catalytic oxidizer.
•
The DPF regeneration fault lamp is lit and matched after maintenance.
•
Repair and replace the DPF regeneration control module.