28
3.15 SUN (Sunroof Initialization)
This function can set the sunroof lock off, close in rain, memory function of sliding /
tilting sunroof, outside temperature threshold, etc.
•
When the gearbox is disassembled or repaired (after some of the car battery is
powered off), which leads to shift delay or shock problem.
3.16 EGR (EGR Adaption)
3.17 ODO (ODO Reset)
3.18 AIR BAG (Airbag Reset)
3.19 TRANSPORT (Transport Mode)
This function can learn the EGR (Exhaust Gas Recirculation) valve after it is cleaned or
replaced.
his function can copy and write the value of kilometers in the chip of the odometer so
that the odometer shows the actual mileage.
This function resets the airbag data to clear the airbag collision fault indicator, so that
the airbag computer in the vehicle can run normally.
This function can deactivate the transport mode, so that the vehicle can function
normally.
It can perform in the following cases:
It needs to be performed in the following cases:
•
When the mileage is incorrect due to the damaged vehicle speed sensor or the
odometer failure.
•
When the vehicle collides and the airbag deploys, the corresponding fault code of
the collision data appears, the airbag indicator lights up, and the fault code cannot
be cleared.
3.12 SUS (Suspension Level Calibration)
3.13 AFS (Adaptive Front-lighting System Reset)
This function is required to calibrate the level of the vehicle when the level sensor or
control module in the air suspension system is replaced or when the level of the vehicle
is incorrect.
This function enables you to initialize the adaptive headlamp system.
3.14 GEAR BOX (A/T Learning)
This function helps complete the gearbox self-learning to improve gear shifting quality.
It needs to be performed in the following cases:
To Next Page
Loading...
