29
EN
3.20 A/F (A/F Reset)
This function can set or learn Air/Fuel ratio parameters.
It needs to be performed in the following cases:
•
When the following functions disabled including limiting the vehicle speed, not
waking up the door opening network, and disabling the remote control key, etc. in
order to reduce the power consumption.
3.21 STOP/START (Stop/Start Reset)
This function can open or close the automatic start-stop function via setting the
hidden function in ECU (provided that the vehicle has a corresponding hidden function
supported by hardware).
3.23 ADBLUE (Diesel Engine Exhaust Gas Filter)
3.24 SEATS (Seat Calibration)
3.25 COOLANT (Coolant Bleeding)
3.26 TYPE (Tire Reset)
3.27 WINDOWS (Windows Calibration)
3.28 LANGUAGE (Language Change)
After the diesel exhaust treatment fluid (car urea) is replaced or filled up, urea reset
operation is required.
This function can match the seats with memory function that are replaced and repaired.
This function can activate the electronic water pump before venting the cooling system.
This function can set the size parameters of the modi ed or replaced tire.
This feature can perform door window matching to recover ECU initial memory, and
recover the automatic ascending and descending function of power window.
This function can change the system language of the vehicle central control panel.
3.22 NOX (NOx Sensor Reset)
This function can reset the catalytic converter learned value stored in the engine ECU.
It needs to be performed in the following cases:
•
When the NOx fault is re-initialized and the NOx catalytic converter is replaced.
To Next Page
Loading...
