Shenzhen TOPFLYTECH Co., Limited. All Rights Reserved 9
times, then all the LED will be flashing. The tracker will power on.
6.3 The battery
6.3.1 Recommend connecting the device to a 5V 1A (cellphone) adaptor through
magnet USB cable for 10 hours charging to make sure the battery is fully charged.
6.3.2 Customer also can connect the tracker to other USB connectors. But lower current
output will cause longer charging time.
6.3.3 When the battery voltage value drops to 3.4V, usually a battery charging is
needed to avoid unexpected shutdown due to low power. If the battery runs out
completely, only when the battery is charged to 3.4V, the device will power on
again.
6.4 Get Current Position
6.4.1 SMS Query (only when the device in working mode and registered on the network)
Device default PIN is 0000. Send a location inquiry SMS command (google,0000#)
to the tracker. The location information will be sent back through SMS (the tracker
SIM card must support receiving and sending SMS first).
6.4.2 Platform Query
Connect your tracker to the tracking platform then check the real-time position
online. (Additional tracking service charge may happen. Contact with your service
provider to get more details)
7. Alarm Configuration
7.1 Alarm sent through network
7.1.1 alarm_set,0000,a,b,0,0,#
7.1.2 0000 is device default PIN
7.1.3 a=alarm code, value from 1 to 31
To Next Page
Loading...
