Toptech TT-N-411 - Installing Your New Thermostat; Testing Your New Thermostat; Important Pre-Test Safety Guidelines; Operational System Testing

1
For installation by experienced service
technicians only. Follow applicable codes.
TTN-100-02
4 Operating Your Thermostat
5 Additional Operation Features
6 Thermostat Maintenance
Install your new TopTech thermostat in 5 basic steps:
1 InstalltheSub-Base
2 ProvidePower
3 ConnectYourWires
4 SetInstallerSwitches
5 AttachThermostattoSub-Base
Install the Sub-Base:
•Removethesub-basefromthebodyofthethermostat.
•Mountthesub-baseasshownbelow:
1
2
Installation
Warning
Disconnect power before beginning installation.
Thermostat Location
Installthethermostatapproximately4-5feet(1.2-1.5m)abovetheoorin
anareathathasagoodamountofaircirculationandmaintainsanaver-
ageroomtemperature.
Avoidinstallationinlocationswherethethermostatcanbeaffectedby
drafts,deadairspots,hotorcoldairducts,sunlight,appliances,concealed
pipes,chimneysandoutsidewalls.
Drill 3/16” pilot holes in
your desired location.
Use supplied anchors for
drywall or plaster.
Provide Power
•For 24 Volt AC power,youmustconnectthecommonsideofthetrans-
 formertotheCterminalonthethermostatsub-base.
•For primary or back-up power,insertthe2supplied“AA”typealkaline
 batteriesintothebatterycompartmentlocatedonthefrontofthether-
 mostatnearthebottom.MakesuretopositionthePositive(+)and
 Negative(-)sides ofthebatteriescorrectlywiththe+/-symbolsinthe
 batterycompartment.
2
Non-Programmable Thermostats
®
Upto2Heat/1Cool
ConventionalandHeatPump