Torin BIG RED TR4053 - User Manual

Questions and Answers

L
Lisa HarperJul 29, 2025
What to do if my Torin BIG RED TR4053 Jacks will not lift load?
- A
  Alexander LoweJul 29, 2025
  If your Torin BIG RED Jacks won't lift a load, it could be due to several reasons. First, ensure the release valve is completely closed by turning the handle clockwise. Also, check if you've exceeded the weight capacity. Air in the hydraulics or a low oil level can also prevent lifting. In the case of low oil level, add oil as required. Finally, a malfunctioning power unit might be the cause, requiring replacement.
S
Sheri GarciaAug 4, 2025
Why is my Torin BIG RED TR4053 lifting poorly?
- D
  Dylan AllenAug 4, 2025
  Poor lifting performance in your Torin BIG RED Jacks can stem from a few issues. The first thing to check is whether there's air in the hydraulics; if so, purge the air from the system. Also, verify the oil level and add oil if it's low. Lastly, the power unit might be malfunctioning, which would require replacing it.
K
Krista CampbellAug 10, 2025
What to do if Torin BIG RED Jacks will not hold load?
- A
  Angela MillerAug 10, 2025
  If your Torin BIG RED Jacks won't hold a load, several factors could be responsible. Make sure the release valve is fully closed by turning the handle clockwise. Another potential cause is a low oil level, so check and add oil as needed. In some cases, the power unit may be malfunctioning, necessitating its replacement.
J
Johnny AustinAug 16, 2025
How to fix Torin BIG RED Jacks that will not lower?
- J
  Jeffrey DavilaAug 16, 2025
  If your Torin BIG RED Jacks won't lower, consider these possible causes. The oil reservoir might be overfilled; if so, drain the excessive oil and lubricate moving parts. Also, check for any binding or foreign obstructions. Low oil level can also be the reason, so add oil as required.
R
Renee PierceAug 22, 2025
Why Torin BIG RED Jacks will not lift to full extension?
- A
  Anthony BrownAug 22, 2025
  If your Torin BIG RED Jacks isn't reaching its full extension, there are a few potential reasons. Start by checking the oil level and adding oil if it's low. Also, air in the hydraulics can cause this issue. Finally, a malfunctioning power unit can prevent full extension.