Torin BIG RED T830025

Questions and Answers

C
Carrie MathewsJul 30, 2025
What to do if my Torin BIG RED jack will not lift the load?
- B
  Brent MunozJul 30, 2025
  If your Torin BIG RED jack won't lift a load, ensure the release valve is completely closed by turning the handle clockwise. It may also be due to exceeding the weight capacity. Check the oil level and add oil if it's low. Air in the hydraulics can also be a factor, so purge the air from the system. If these steps don't resolve the issue, the power unit may be malfunctioning and require replacement.
S
Suzanne SteeleAug 4, 2025
What to do if my Torin BIG RED jack will not hold the load?
- Z
  zowensAug 4, 2025
  If your Torin BIG RED jack is not holding the load, make sure the release valve is fully closed by turning the handle clockwise. A low oil level could also be the cause, so add oil as needed. If the issue persists, the power unit might be malfunctioning and require replacement.
L
Luke MarksAug 11, 2025
Why my Torin BIG RED jack will not lift to full extension?
- S
  Selena OlsenAug 11, 2025
  If your Torin BIG RED jack will not lift to full extension, it might be due to a low oil level, so add oil as required. Alternatively, the power unit may be malfunctioning and need to be replaced.
E
Eric MorganAug 17, 2025
Why is my Torin BIG RED jack lifting poorly?
- I
  Isaiah SimsAug 17, 2025
  If your Torin BIG RED jack is lifting poorly, it could be due to a low oil level, so add oil as required. It's also possible that the power unit is malfunctioning, in which case you should replace it.
S
Steven WuAug 23, 2025
What to do if my Torin BIG RED jack will not lower?
- A
  Anita WileyAug 23, 2025
  If your Torin BIG RED jack won't lower, it might be because the oil reservoir is overfilled; drain the excessive oil and lubricate moving parts. Additionally, check for any binding or foreign obstructions.