Need help?Do you have a question about the Tormach pathpilot and is the answer not in the manual?
General| Operating System | Linux |
|---|---|
| Programming Language | G-code |
| Software Base | LinuxCNC |
| Control Type | CNC |
| Supported Machines | Tormach Mills |
| Features | Rigid Tapping, Conversational Programming |
| Motion Control | Real-time |
| Connectivity | Ethernet, USB |
| Type | CNC Controller Software |
| Compatibility | Tormach Machines |
| Supported File Formats | G-code, DXF |
| User Interface | Graphical User Interface (GUI) |
Lists necessary tools and items for controller arm installation.
Warns about sharp objects and the need for protective gear.
Locating the mounting pad and securing the square tube arm.
Orienting the monitor bracket and installing the monitor post.
Installing the end plug and wire tie mounts on the arm.
Lists necessary tools for operator console installation.
Securing the operator console and keyboard tray to the arm.
Installing the power supply and connecting cables to the console.
Routing and securing cables through the keyboard tray.
Connecting pendant, Ethernet, and power cables to the machine.
Modifying jumper wire in the electrical cabinet.
Resolving touchscreen not responding to input.
Troubleshooting console power reception and status.
Fixing scrambled or illegible console screen output.
Diagnosing issues with override knobs.
Troubleshooting non-responsive buttons.
To Next Page
