59
Small Knife Holder SVM-00
SMALL KNIVES
Positioning of Machine
Grinding direction: Towards or away from the edge.
Note The height of the bench
must not be too high when
grinding towards the edge.
550–650 mm (22–26") is suitable
depending on your height.
Design
The Small Knife Holder SVM-00 complements the Tormek
Knife Jig SVM-45. It extends the usage so that you can
also sharpen even the smallest knives.
It consists of a Guide Bar (1), a Handle Grip (2), and an
Adjustable Clamp (3). The knife handle is fastened with
the Knob (4). The holder is designed to securely hold the
knife without damaging the handle.
The Guide Bar (1) mounts in the jaws of the Tormek Knife
Jig SVM-45 and you sharpen using the same technique
as for the knife jig. The exact edge angle is set by turning
the Adjustable Stop (6) or using the Micro Adjust on the
Universal Support.
Various carving knives, skew knives
and pocket knives.
SVM-45
To Next Page
Need help?
General
