Why is the pump motor not working on my Tornado 98250 Floor Machine?
If the pump motor is not working on your Tornado Floor Machine, it could be due to loose wiring (tighten the wiring), a defective pump pressure switch (replace it with a new pressure switch assembly), or motor burnout (replace the pump motor).
What to do if my Tornado 98250 has low vacuum at the wand?
If the vacuum motor is running on your Tornado Floor Machine, but there's low or no vacuum at the wand, consider these possibilities: * Ensure the drain hose is closed. * Check the vacuum hose for defects or kinks; repair or replace if needed. * Open the machine and connect the vacuum hose to the recovery tank if it's disconnected. * Make sure the recovery tank lid is not damaged and is closed properly; replace the lid if damaged. * Clean out any lint or accumulated dirt from the ball type shutoff screen. * Inspect hose connections for leaks around the stand pipe, clamps, and cuffs of the vacuum motor; replace any damaged hoses. * Check for blockages in the vacuum motor exhaust by removing the hose from the machine and feeling the exhaust under the machine; remove any obstru...
General| Brand | Tornado |
|---|---|
| Model | 98250 |
| Category | Floor Machine |
| Language | English |
To Next Page
