10
To replace the light bulb.
1. Unplug the vacuum.
2. Insert a flat tipped screwdriver into slot A and remove light lens.
3. Grasp bulb and pull out. Discard old bulb and replace with new one.
4. Replace light lens.
Vacuum cleaner won’t run.
Possible Causes Remedies
Vacuum Cleaner is not plugged in
Household fuse/circuit breaker tripped
Check power Source Plug and Connector Plug
Check/replace fuse – Reset breaker
Vacuum cleaner won’t pick up dirt.
Possible Causes Remedies
Dust Bag is full
Drive Belt not functioning
Rotating Cleaning Brush bristles worn
Rotating Cleaning Brush jammed
Dust Tube is clogged
Replace with new Dust Bag
Realign Drive Belt or replace if damaged
Replace Rotating Cleaning Brush
Remove Rotating Cleaning Brush and clean
debris from brush ends; Reinstall Drive Belt
Clean Dust Tube
Accumulation of dust inside Cloth Bag
Possible Cause Remedies
Dust Bag is clogged or dirty
Dust Bag collar retainer not secure
Inlet clogged
Replace with new Dust Bag
Secure Dust Bag collar retainer
Shake dust down to bottom of Dust Bag.
Troubleshooting
WARNING: To avoid electrical shock or injury from moving parts, always turn OFF the Power
Switch and unplug the Power Source Plug before performing maintenance or trouble shooting.
Always unplug by grasping the Power Source Plug;
NEVER pulling on the Power Cord to unplug.
To Next Page
Loading...
Need help?
General
