7
WARNING: Plastic bags or film can be dangerous. To avoid danger of
suffocation, keep away from babies and children.
The dual Suction System is packaged for convenience and requires
minimal assembly.
The only tool you will need is a Phillips head screwdriver.
1. Slide the handle Tube into the Connector, aligning the hole in the
Handle Tube with the molded hole at the top of the Connector.
2. Hold the hex nut in front of the Connector in the hex shaped cavity
while inserting the screw with your finger from the back. Tighten the
screw while placing your finger over the hex cavity to hold the hex nut in
place. After a few turns, tighten further with a Phillips head screwdriver.
Do not overtighten.
3. Slide screw through plastic Cord Hook from the inside of Cloth Bag.
Align screw with hole in Handle Tube. Tighten screw.
4. Remove screw from Filter Cover. Remove Filter Cover. Insert the
Connector Plug into the back of the unit at the rear of the Powerfoot
– Make sure the Connector Plug is fully inserted. Replace Filter Cover.
Replace Filter Cover Screw.
Your Vacuum cleaner is now ready to use.
Tip. Before cleaning under low furniture, always check area first for
objects that might harm the Rotating Cleaning Brush or get caught in the
Dust Tube.
Power Supply
The Power Cord is stored at the back of the vacuum cleaner, and is
looped around the Quick Release Cord Hooks. The polarized Power
Source Plug is designed to attach to the Power Cord during storage.
Before using, make sure the Connector Plug is securely attached to the
Powerfoot and that the Power Source Plug is plugged into a polarized
outlet.
Power Switch
The Power Switch is located in the Handle of the cleaner. Push down (I) to
turn ON. Push up (O ) to turn OFF.
Power Cord Storage
When you are finished using your vacuum, return it to the upright
position. Make sure the vacuum is turned OFF. Always unplug the
vacuum by grasping the Power Source Plug (NOT the Power Cord) and
disconnecting from the outlet. Properly store the Power Cord by winding
the cord around the Quick Release Cord Hooks on the back of the
vacuum in a continuous loop, or by hanging the cord on the Cord Storage
Hook located on the front of the vacuum. Attach the Power Source Plug
to the Power Cord.
Operation
This vacuum, with Dual Suction System is designed to effectively and
safely clean all types of carpeting, wood, linoleum, and vinyl floors. Its
wide 14-inch Powerfoot makes cleaning quick and easy.
To place the vacuum in position for use, lightly press your foot on the
Powerfoot and tip the Handle backwards.
To Next Page
Loading...
Need help?
General
