8
Routine Maintenance
For maximum performance from your vacuum, check and
maintain vacuum parts regularly.
Replacing the Dust Bag
Check the Dust Bag weekly. Replace the Dust Bag when it is
near full or when cleaning suction diminishes. Never reuse a
Dust Bag.
WARNING: To avoid electrical shock or injury from moving
parts, always turn OFF the Power Switch and unplug the
Power Source Plug before performing maintenance
or trouble shooting. Always unplug by grasping the Power
Source Plug; NEVER pulling on the Power Cord to unplug.
Tip: Vacuuming new carpet or vacuuming fine powders may
clog the Dust Bag. Check Dust bag often.
Unplug vacuum by grasping and pulling on the Power
Source Plug.
Unzip Cloth Bag. Remove collar retainer by pressing on the
two tabs and pulling the top towards you. Dispose of Dust
Bag.
Slide collar of new Dust Bag completely into collar retainer.
Push collar retainer back into position and secure in place.
Tuck the remainder of the Dust Bag completely inside the
Cloth Bag. Make sure it lays flat, top to bottom, without
bunching. Zip Cloth Bag.
Cleaning the Dust Tube
The vacuum features Dust Tube designed to optimize
cleaning power. For best performance, routinely check and
clear excess dust and other debris.
Note: Cover floor with newspaper to catch any loose
material or dust removed during cleaning.
Release Bag Tension Spring.
Remove Filter Cover screw and then remove Filter Cover.
Unplug Connector Plug.
Locate the Tube Release Button at the top of the Powerfoot.
The Tube Release Button is hidden under a Rubber Collar
on the side of the Dust Tube and can be pressed through
the Rubber Collar. Lift off the Dust Tube while pressing on
the Tube Release Button.
Use a wire brush to clean out the inside of the Dust Tube
and the top section of the Powerfoot where they connect.
Reconnect the tube with the Powerfoot. It should snap into
place. Make sure that the tube release button on the Tube
lines up with the Tube Release Button on the Rubber Collar.
Plug the Connector Plug back into base of vacuum.
WARNING: To avoid electrical shock or injury from moving
parts, always turn OFF the Power Switch and unplug the
Power Source Plug before performing maintenance
or trouble shooting. Always unplug by grasping the Power
Source Plug; NEVER pulling on the Power Cord to unplug.
To Next Page
Loading...
Need help?
General
