Issued: 01.04.11 Approved: Mod. No. 5060358 Sheet 39 of 64 Part No. 111-4431 (A)
SAFETY CAB GENERAL ASSEMBLY - ASSEMBLY Continued
17. Ensure straps are positioned to the back of the cab.
Allowing the front of the cab to tilt in a forward direction.
Refer to Fig 35.
18. Carefully guide the cab assembly over the vehicle using the
lifting equipment and lower with the front of the cab tilting
forward. Refer to Fig 35 and Fig 36.
19. Loosely bolt the front pivot plates in position. Refer to Fig
37.
20. Lower the cab fully onto the platform and ensure that it is
correctly positioned and supported around the base. Refer
to Fig 38.
Fig 35
Fig 36
Fig 37
Fig 38
To Next Page
Loading...
