Toro 02750 - Page 40

Issued: 01.04.11 Approved: Mod. No. 5060358 Sheet 40 of 64 Part No. 111-4431 (A)
SAFETY CAB GENERAL ASSEMBLY - ASSEMBLY Continued
21. Push the pivot retaining pins towards the centre to fully
engage with the original platform pivot pin at the front of
the cab assembly and retain with the M6 screws, nuts and
washers provided.
22. Finally tighten the pivot plate fasteners to the recommended
torque. Refer to page 42.
23. Drill ten holes 8.5 mm diameter through the operator
platform, using the cab frame holes as a template. Three
on each side as shown in Fig 39 and four in the rear frame
as shown in Fig 40.
CAUTION: PREVENT ACCIDENTS - Take extreme care
when drilling at the rear of the cab frame to avoid damage
to the fuel tank.
24. Assemble the M8 bolts, nuts and washers provided to secure
the six locations around the door apertures to the platform,
tighten the fasteners securely and t the blanking plugs.
25. Using the lifting equipment, carefully raise the cab/
platform assembly to the service position and ret the gas
strut. (Note: Where a cab lifting kit has been tted the gas
strut is not required).
26. Fit the 2 platform retaining cable assemblies through the
front holes of the pivot brackets located beneath the operator
platform and the existing lower M8 setscrews which attach
the latching bar assembly to chassis assembly. Use the
M8*30 setscrews, nuts and washers to attach the cable
upper ends to the pivot brakes. Tighten the nyloc nuts just
sufciently to enable the cable ends to self-align under
tension. Refer to Fig 41.
27. Assemble the nal six bolts, nuts and washers required to
secure the rear of the cab to the platform. Tighten the
fasteners securely.
28. Drill a 14 mm diameter hold on the LH rear side of the
platform and feed the washer bottle wiring and water tubing
through. Refer to Fig 42.
Fig 39
Fig 40
Fig 41
Fig 42