42
Contact with the reel or other moving parts can
result in personal injury.
Caution
7. To make an adjustment to the cutting units while
backlapping, turn the reels OFF by pushing in on the
knob on the instrument panel and turning the engine
OFF. After adjustments have been completed, repeat
steps 4–6.
8. When the backlap operation is completed, stop the
engine, rotate the backlap knob clockwise to the MOW
position, set the reel speed controls to the desired
mowing setting and wash all lapping compound off of
the cutting units.
Note: Additional instructions and procedures on
backlapping are available in the TORO Sharpening Reel &
Rotary Mowers Manual, Form No. 80-300SL.
Note: For a better cutting edge, run a file across the front
face of the bedknife when the lapping operation is
completed. This will remove any burrs or rough edges that
may have built up on the cutting edge.
To Next Page
Loading...
Need help?
General
