Toro 03530 - Page 30

30
Maintenance
Maintenance Procedure Maintenance Interval & Service
✝Initial break in at 10 hours
‡Initial break in at 50 hours
Change hydraulic fluid
✝Change transmission fluid
✝Replace transmission filter
Check rear wheel toe-in
Rear axle service
–Pack rear axle bearings (2-wheel drive)
–Change rear axle lubricant (4-wheel drive)
Replace moving hoses
Replace safety switches
Flush the cooling system and replace fluid
Drain and flush the fuel tank
Drain and flush the hydraulic tank
Service the air filter
Replace the fuel pump filter
Replace the fuel/water separator filter
Inspect traction linkage movement
‡Torque head and adjust valves
‡Check engine rpm (idle and full throttle)
Drain moisture—hydraulic tank
Drain moisture—Fuel tank
Check the reel bearing preload
✝Torque wheel lug nuts
✝Check
fan and
alternator
belt tension
‡Replace engine oil filter
Inspect cooling system hoses
Check battery fluid level
Check battery cable connectors
Lubricate all grease fittings
Change engine oil
Instpect air filter, dust cup and baffle
Every
400 hours
Every
800 hours
Every
200 hours
Every 100
hours
Every 50
hours
Minimum Recommended Maintenance Intervals
Annual Recommendations:
Items are recommended every 1600 hours or
two years, whichever occurs first.