27
1
2
Figure 38
1. Reel drive belt 2. Bearing housing mounting
nuts
B. Using a 3/8 in. drive torque wrench, rotate the
bearing housing with 35–40 in.-lb. of torque to set
belt tension (Fig. 39)
2
1
Figure 39
1. Bearing housing 2. 3/8” Torque wrench here
C. Tighten the bearing housing mounting nuts
(Fig. 38). Do not over-tension belt.
D. Install belt cover.
Reel Drive Belt (Transmission coupler)
1. Remove the belt cover mounting fasteners and belt
cover to expose belt (Fig. 40).
1
Figure 40
1. Belt cover
2. Check tension by depressing belt (Fig. 41) at mid span
of pulleys with 4 ± 1 lb. of force. Belt should deflect
1/4 in. If deflection is incorrect, proceed to next step.
1
Figure 41
1. Reel drive belt
To Next Page
Loading...
