29
Figure 31
Figure 32
Figure 33
Changing the Engine Oil and
Filter
Change the oil and filter after the first 8 hours of operation.
Thereafter, change the oil every 50 hours and the filter
every 100 hours.
1. Remove the drain plug (Fig. 34) and let oil flow into a
drain pan. When the oil stops, install the drain plug.
1
2
Figure 34
1. Drain plug 2. Oil filter
2. Remove the oil filter (Fig. 34). Apply a light coat of
clean oil to the new filter gasket.
3. Screw the filter on by hand until the gasket contacts the
filter adapter, then tighten 1/2 to 3/4 turn further. Do
not overtighten.
4. Add oil to the crankcase; refer to Checking the Engine
Oil, page 17.
5. Dispose of the used oil properly.
To Next Page
Loading...
