8
Assembly
Loose Parts
Note: Use the chart below to verify all parts have been shipped.
DESCRIPTION QTY. USE
Valve Lever 1 Install valve lever
Key 2 Start the engine
Oil filter 1 Break–in oil change
Chain link 2 Spare parts
Installing the Valve Lever
1. Thread the lever into the pump selector valve
(Fig. 1).
Note: The lever should be installed with the
bend toward the operator.
2. Tighten the jam nut on the lever to lock it in
position.
1
m–3883
Figure 1
1. Pump selector lever
Activating the Battery
The traction unit is shipped with a dry battery.
Purchase bulk electrolyte with 1.260 specific gravity
from a local battery supply outlet.
1. Remove the wing nut and bolt securing the
battery clamp and strip (under the clamp) and
remove the clamp and strip (Fig. 2).
1
5
3
m–3953
2
4
Figure 2
1. Battery
2. Battery clamp
3. Positive cable
4. Rubber cover
5. Negative cable
To Next Page
Loading...
