Toro 22333 User Manual (English)

Questions and Answers:

M
Mrs. Valerie MaysAug 16, 2025
Why is the starter not cranking on my Toro Compact Loader?
- K
  kristinrobinsonAug 16, 2025
  If the starter on your Toro Compact Loader isn't cranking, it could be due to several reasons. First, check for corroded or loose electrical connections and ensure they have good contact. A blown or loose fuse could also be the culprit, so correct or replace the fuse. If the battery is discharged, try charging or replacing it. For issues related to a damaged relay, switch, starter, starter solenoid, or seized internal engine components, it's best to contact your Authorized Service Dealer.
H
heatherguerreroAug 18, 2025
What to do if my Toro Compact Loader engine overheats?
- K
  Kristina SandersAug 19, 2025
  If your Toro Compact Loader's engine is overheating, there are several potential causes. Begin by checking the coolant level and adding more if needed. Inspect and clean the radiator screen regularly to ensure unrestricted airflow. Verify the crankcase oil level is at the correct mark, and reduce the machine load or ground speed if it's excessive. Ensure you're using the correct fuel. For issues related to a damaged thermostat, fan belt, incorrect injection timing, or a damaged coolant pump, contact your Authorized Service Dealer.
A
Angela MurphyAug 25, 2025
What causes my Toro Compact Loader engine to lose power?
- S
  Sean HallAug 26, 2025
  If the engine of your Toro Compact Loader is losing power, consider the following: Reduce ground speed if the engine load is excessive. Ensure the crankcase oil level is correct by filling or draining to the full mark. Service dirty air cleaner filters. If there's dirt, water, stale fuel, or incorrect fuel in the fuel system, drain and flush the system and add fresh fuel. Clean or replace the spark arrestor screen if it's clogged. Bleed the nozzles and check for air leaks at fuel hose connections and fittings between the fuel tank and engine if there is air in the fuel. For issues related to low compression, a restricted fuel tank vent, incorrect injection pump timing, or a damaged injection pump, contact your Authorized Service Dealer.
S
Savannah BrownAug 27, 2025
Why does my Toro Compact Loader engine start but not stay running?
- J
  Joshua BrownAug 27, 2025
  If your Toro Compact Loader starts but doesn't keep running, check these potential causes: Ensure the fuel tank vent isn't restricted by loosening the cap; if the engine runs with the cap loosened, replace the cap. Drain and flush the fuel system and add fresh fuel if dirt or water is present. Replace a clogged fuel filter. If there's air in the fuel, bleed the nozzles and check for air leaks at fuel hose connections and fittings between the fuel tank and engine. If you're using an improper fuel grade for cold weather, drain the fuel system, replace the fuel filter, and add fresh fuel of the proper grade. Clean or replace the spark arrestor screen if it's clogged. For a damaged fuel pump, contact your Authorized Service Dealer.
M
Mark MccannAug 31, 2025
What causes excessive black smoke from the Toro Compact Loader exhaust?
- J
  jennifer14Aug 31, 2025
  If your Toro Compact Loader is producing excessive black smoke from the exhaust, consider these factors: Reduce the load or use a lower ground speed if the engine load is excessive. Service the air filters if they are dirty. If incorrect fuel is in the fuel system, drain it and refill with the specified fuel. For issues related to incorrect injection pump timing, a damaged injection pump, or damaged injection nozzles, contact your Authorized Service Dealer.
K
Kelsey DelacruzSep 3, 2025
Why does my Toro Compact Loader engine knock or miss while running?
- B
  Briana WrightSep 3, 2025
  If your Toro Compact Loader engine runs but knocks or misses, consider the following: If there's dirt, water, stale fuel, or incorrect fuel in the fuel system, drain and flush the fuel system and add fresh fuel. Bleed the nozzles and check for air leaks at the fuel hose connections and fittings between the fuel tank and engine if there is air in the fuel. For issues related to damaged injection nozzles, low compression, incorrect injection pump timing, excessive carbon build-up, or internal wear or damage, contact your Authorized Service Dealer.
M
melaniefrazierSep 6, 2025
What causes excessive white smoke from the Toro Compact Loader exhaust?
- S
  Stacy DiazSep 6, 2025
  If your Toro Compact Loader is emitting excessive white smoke from the exhaust, consider these possible causes: Ensure the key wasn't turned to the start position before the glow plug light turned off; if so, turn the key to the run position and allow the glow plug light to turn off before starting the engine. Check the thermostat if the engine temperature is low. Check the fuse, glow plugs, and wiring if the glow plugs are inoperative. For issues related to incorrect injection pump timing, damaged injection nozzles, or low compression, contact your Authorized Service Dealer.
E
elizabeth48Sep 8, 2025
How to fix a Toro Compact Loader engine that will not idle?
- K
  Kent FloresSep 9, 2025
  If your Toro Compact Loader engine won't idle, check these potential causes: Loosen the fuel cap to ensure the fuel tank vent isn't restricted; replace the cap if the engine runs with it loosened. Drain and flush the fuel system and add fresh fuel if there's dirt, water, stale fuel, or incorrect fuel in the system. Service dirty air cleaner filters. Replace a clogged fuel filter. If there is air in the fuel, bleed the nozzles and check for air leaks at fuel hose connections and fittings between the fuel tank and engine. For a damaged fuel pump or low compression, contact your Authorized Service Dealer.

Toro 22333 Specifications

General

Brand	Toro
Model	22333
Category	Compact Loader
Language	English

Summary

Safety Warnings

California Proposition 65 Warning

Details California Proposition 65 warning concerning diesel engine exhaust.

Safety Alert Symbol Explanation

Explains the hazard identification symbol and its meaning.

Safe Operation

Safe Operating Practices

General guidelines for operating the equipment safely.

Operator Training and Preparation

Emphasizes operator training and pre-operation checks for safety.

Operation Guidelines

Instructions for operating the machine safely in various conditions.

Slope Operation

Safety and Instructional Decals

Setup Procedures

Activating the Battery

Step-by-step guide to preparing and activating the battery.

Charging the Battery

Instructions for charging the battery correctly.

Checking Fluid Levels

How to check essential fluid levels before operation.

Product Overview

Controls and Operation

Traction Control System

Explains how to operate the traction control for movement and steering.

Loader Arm and Attachment Controls

Details operation of loader arm and attachment tilt levers.

Indicator Lights and Gauges

Explains the function of various indicator lights and gauges.

Specifications

Stability Data

Operation

Fueling and Oil Checks

Procedures for filling the fuel tank and checking engine oil level.

Hydraulic Fluid Check

Instructions for checking the hydraulic fluid level.

Engine Coolant and Fuel System

Engine Coolant Management

Procedures for checking, adding, and bleeding engine coolant.

Fuel System Bleeding

How to bleed air from the fuel system.

Starting and Stopping Procedures

Starting and Stopping the Engine

Steps for starting and safely stopping the engine.

Stopping the Traction Unit

Procedures for safely stopping the entire traction unit.

Moving and Securing

Moving a Non-functioning Unit

How to move the unit if it is not operational.

Cylinder Lock Usage

Instructions for installing and removing the cylinder lock for safety.

Attachment Installation

Hydraulic Connections and Transport

Connecting Hydraulic Hoses

How to connect hydraulic hoses for attachments.

Securing for Transport

Methods for safely securing the unit for transport.

Maintenance Schedule

Premaintenance Procedures

Opening and Closing Covers

Steps for safely opening and closing access covers.

Lubrication and Cleaning

Greasing the Traction Unit

Instructions for greasing the traction unit's pivot joints.

Engine Maintenance

Servicing the Air Cleaner

Procedures for cleaning and replacing air cleaner filters.

Engine Oil Servicing

Changing the Engine Oil

Step-by-step guide to changing the engine oil and filter.

Fuel System Maintenance

Fuel Line and Filter Checks

Inspecting fuel lines and draining the fuel filter/water separator.

Electrical System Maintenance

Servicing the Battery

Guidance on servicing the battery, including electrolyte and charging.

Drive System Maintenance

Cleaning and Adjusting Tracks

Procedures for cleaning tracks and adjusting track tension.

Track Tension Adjustment

Replacing Tracks

Road Wheel Maintenance

Cooling System Maintenance

Servicing the Cooling System

Information on servicing the cooling system and radiator.

Controls System Maintenance

Adjusting Traction Control Alignment

Steps to adjust the alignment of the traction control system.

Traction Control Adjustments

Neutral Position Adjustment

How to adjust the neutral position of the traction control.

Tracking Adjustment (Forward)

How to adjust tracking for straight movement in forward gear.

Hydraulic System Maintenance

Replacing Hydraulic Filter

Steps for replacing the hydraulic filter.

Hydraulic Fluid and Lines

Changing Hydraulic Fluid

Procedure for changing the hydraulic fluid.

Checking Hydraulic Lines

Inspecting hydraulic lines and hoses for wear or leaks.

Cleaning Procedures

Removing Debris

How to remove debris from the traction unit.

Cleaning the Chassis

Instructions for cleaning the chassis.

Storage Instructions

Troubleshooting

Starter Not Cranking

Possible causes and corrective actions for starter issues.

Engine Starting Problems

Troubleshooting steps for when the engine cranks but won't start.

Engine Running Issues

Diagnosing and fixing issues like engine not running or missing.

Engine Overheating and Idle Issues

Troubleshooting engine overheating and idle problems.

Engine Performance Issues

Diagnosing engine power loss and excessive exhaust smoke.

Engine and Drive Issues

Troubleshooting white smoke and traction unit not driving.

Schematics

Electrical Schematic

Diagram of the electrical system of the traction unit.

Hydraulic Schematic

Diagram illustrating the hydraulic system of the traction unit.

Related product manuals

Toro 22303 Dingo 320-D

40 pages

Toro 22333 User Manual

Table of Contents

Questions and Answers:

Toro 22333 Specifications

Summary

Safety Warnings

California Proposition 65 Warning

Safety Alert Symbol Explanation

Safe Operation

Safe Operating Practices

Operator Training and Preparation

Operation Guidelines

Slope Operation

Safety and Instructional Decals

Setup Procedures

Activating the Battery

Charging the Battery

Checking Fluid Levels

Product Overview

Controls and Operation

Traction Control System

Loader Arm and Attachment Controls

Indicator Lights and Gauges

Specifications

Stability Data

Operation

Fueling and Oil Checks

Hydraulic Fluid Check

Engine Coolant and Fuel System

Engine Coolant Management

Fuel System Bleeding

Starting and Stopping Procedures

Starting and Stopping the Engine

Stopping the Traction Unit

Moving and Securing

Moving a Non-functioning Unit

Cylinder Lock Usage

Attachment Installation

Hydraulic Connections and Transport

Connecting Hydraulic Hoses

Securing for Transport

Maintenance Schedule

Premaintenance Procedures

Opening and Closing Covers

Lubrication and Cleaning

Greasing the Traction Unit

Engine Maintenance

Servicing the Air Cleaner

Engine Oil Servicing

Changing the Engine Oil

Fuel System Maintenance

Fuel Line and Filter Checks

Electrical System Maintenance

Servicing the Battery

Drive System Maintenance

Cleaning and Adjusting Tracks

Track Tension Adjustment

Replacing Tracks

Road Wheel Maintenance

Cooling System Maintenance

Servicing the Cooling System

Controls System Maintenance

Adjusting Traction Control Alignment

Traction Control Adjustments

Neutral Position Adjustment

Tracking Adjustment (Forward)

Hydraulic System Maintenance

Replacing Hydraulic Filter

Hydraulic Fluid and Lines

Changing Hydraulic Fluid

Checking Hydraulic Lines

Cleaning Procedures

Removing Debris

Cleaning the Chassis

Storage Instructions

Troubleshooting

Starter Not Cranking

Engine Starting Problems

Engine Running Issues

Engine Overheating and Idle Issues