260 Series Tractor Service Manual 2 - 5
CHASSIS
2. Remove right and left tie rods from the front
spindle arms (Figure 17).
Figure 17
MVC-105X
3. On the front of the axle, in the center, remove the
E-ring and washers (Figure 18).
Figure 18
MVC-106X
4. Remove the electric PTO clutch from the engine
crankshaft.
5. On the back side of the axle, remove the bolt on
the axle pin (Figure 19).
Figure 19
MVC-107X
6. Remove the axle pin; use a drift punch and
hammer to tap the axle pin out; if needed (Figure
20).
Figure 20
MVC-108X
7. Installation – reverse the order of removal.
To Next Page
Loading...
