260 Series Tractor Service Manual 3 - 3
TUFF TORQ TRANSAXLE
9. Remove the 3 screws retaining the transaxle fan
to the input pulley; this will give you enough
clearance to remove the drive belt from the
transaxle input pulley (Figure 69).
Figure 69
MVC-328X
10. Use a floor jack and put it under the transaxle to
help lower the transaxle from the frame (Figure
70).
Figure 70
MVC-329X
11. Located on the right front side of the transaxle is a
torque strap. Remove the bolt and nut (Figure
71).
Figure 71
MVC-330X
12. Remove the 4 nuts from the U-bolts which hold
the two axle shafts to the frame (Figure 72).
Figure 72
lMVC-331X
To Next Page
Loading...
