260 Series Tractor Service Manual 3 - 5
TUFF TORQ TRANSAXLE
4. Bolt the forward/reverse control rod to the control
shaft assembly (Figure 77).
Figure 77
MVC-325X
5. Before installing the brake rod trunnion into the
brake control lever, make sure the brake control
lever is in its most rearward position and hold it
there. Adjust the trunnion on the brake rod until it
slips into the brake control lever. Secure with
washer and cotter pin (Figure 78).
Figure 78
MVC-322X
6. Attach the freewheeling rod to the lever with a
cotter pin (Figure 79).
Figure 79
MVC-323X
7. Install the hose clamp and the reservoir hose to
the top of the transaxle. Add oil to the reservoir
cup located under the front hood to the cold mark,
located on the side of the cup (Figure 80).
Figure 80
MVC-337X
To Next Page
Loading...
