260 Series Tractor Service Manual 3 - 7
TUFF TORQ TRANSAXLE
1. Disconnect the negative battery cable.
Disconnect the electric PTO clutch wire. There is
a tie strap through the frame of the tractor around
the clutch wire that needs to be cut to release the
clutch wire. Also, remove the battery drain tube
from the tie strap (Figure 84).
Figure 84
MVC-342X
2. Remove the two steering tie rods from the
steering sector gear (Figure 85).
3. Remove the fender, seat, and gas tank (refer to
the “Chassis” section on page 2 - 16
Figure 85
MVC-343X
4. Unhook the idler spring at the bolt and spacer
located on the right side of the frame (Figure 86).
Figure 86
MVC-327X
5. Remove the cotter pin and washer on the brake
rod at the transaxle (Figure 87).
Figure 87
MVC-322X
To Next Page
Loading...
