260 Series Tractor Service Manual 3 - 9
TUFF TORQ TRANSAXLE
10. Loosen the left pedal pivot shaft clamp. Remove
the right pedal pivot shaft clamp (Figure 92).
Figure 92
MVC-351X
11. Unhook the brake rod return spring, located under
the center access plate (Figure 93).
Figure 93
MVC-352X
12. Remove the roll pin holding the brake cross shaft
and slide the shaft out to clear the bushing (Figure
94).
Figure 94
MVC-353X
13. Install the belt around and above the electric
clutch. Feed the belt above the steering sector
gear and over the brake shaft and pedal pivot
shaft (Figure 95).
Figure 95
MVC-354X
(A) Brake Shaft
(B) Pedal Pivot Shaft
(C) Steering Sector
Gear
A
B
C
To Next Page
Loading...
