HYDRO-GEAR TRANSAXLE
4 - 2 260 Series Tractor Service Manual
5. If the tractor is equipped with cruise control,
unplug the cruise control magnet and the reverse
plunger switch wiring plugs (Figure 120).
Figure 120
MVC-137X
6. Unbolt the cruise control magnet bracket from the
side of the frame (Figure 121).
Figure 121
MVC-138X
7. Unhook the Idler pulley spring from the torque
strap bracket (Figure 122).
Figure 122
MVC-139X
8. Remove the gas damper cylinder located next to
the transaxle input pulley. To remove the fastener
on the end of the cylinder, use a small blade
screwdriver and insert the blade of the screwdriver
between the back side of the fastener and the
shaft. Apply a little pressure toward the back of
the fastener and pull the damper cylinder off the
shaft (Figure 123).
Figure 123
MVC-140X
To Next Page
Loading...
